TEACHING >> Electronic Technology >> Contents

           

 

Contents

 
 

   The subject Electronic Technology aims to cover the following TOPICS:

          1. Manufacturing electronic circuits. Introduction

          2. Passive components

          3. Printed circuit boards

          4. Hybrid circuits

          5. Monolythic integrated circuits

          6. Reliability of electronic systems

          7. CAE software

The development of these topics gives place to the LECTURES indicated below.

I. MANUFACTURING ELECTRONIC CIRCUITS. INTRODUCTION

1.- Development of an Electronic Circuit

          1.1. Components

          1.2. Printed circuit boards

          1.3. Hybrid circuits

          1.4. Monolythic integrated circuits

2.- Herramientas de CAE

          2.1. Schematics capture

          2.2. Circuit simulation

          2.3. Printed circuit board design

II. PASSIVE COMPONENTS

3.- Resistors

          3.1. Characteristics of a resistor

          3.2. Types of resistors

          3.3. Potentiometers

          3.4. Normalised symbols

4.- Capacitors

          4.1. Characteristics of a capacitor

          4.2. Types of capacitors

          4.3. Capacitor selection

          4.4. Normalised symbols

          4.5. Capacitor value reading

5.- Inductors and Transformers

          5.1. Principles of electromagnetic theory

          5.2. Inductor design

          5.3. Transformer design

6.- Other Components

          6.1. Switches

          6.2. Relays

          6.3. Batteries

          6.4. Heatsinks

III. PRINTED CIRCUIT BOARDS

7.- Introduction to the Design of PCBs

          7.1. Parts of a printed circuit board

          7.2. Manufacturing process

IV. HYBRID CIRCUITS

8.- Hybrid Circuits

          8.1. Definition

          8.2. Types of hybrid circuits

V. MONOLYTHIC INTEGRATED CIRCUITS

9.- Fabrication of Monolythic Integrated Circuits

          9.1. Basic procedures

          9.2. Types of integrated circuits

          9.3. Custom integrated circuits

          9.4. Semicustom integrated circuits

          9.5. Comparison of  semicustom and full-custom

10.- Design of Integrated Circuits

          10.1. Design sequence

          10.2. Testeability

VI. RELIABILITY OF ELECTRONIC SYSTEMS

11.- Reliability of Electronic Systems

          11.1. Definition

          11.2. Theoretical considerations

          11.3. Examples

VII. CAE SOFTWARE

          This topic will be covered throughout the lab sessions.

 
 
 
 
 

LECTURERS

 

Miguel Ángel José Prieto

(mike@uniovi.es)

 

Juan Antonio Martín Ramos

(jamartin@uniovi.es)

 

Jesús Cardesín Miranda

(cardesin@uniovi.es)

 

Marta Valledor Llopis

(valledormarta@uniovi.es)